Key Part To Turbocharger

The key part of turbocharger bearing which is named of lubrication type. It is also called full floating bearing. This bearing is in high working speed and with bad working environment. So ensure lubrication is very important.

Low oil pressure can lead suppling slowly and turbocharger will be in failure. It will not make such failures occur if the energy started normally. Oil supply will be slow when the energy stated at first time after changing the oil. At the same time, the bearing will be lack of oil lubricated. At this condition, you should idle running for about three minutes after starting. Certainly you could not improve the running quickly. While you also could not stop the energy suddenly on the highway or uphill. You must make the energy running for about one minute in order to prevent shorten oil to the turbocharger bearing. So drivers must obey the rule of manufacturers instructions. At the same time, you should be careful to oil quality.

In fact turbocharger is an air compressor. It increase the air intake quantity by compressed air. Sports cars which take part in the competition are usually equipped with turbocharger on the engine. That can make the car burst out more power. Energy is rely on the fuel combustion in the cylinder to generate power.

The entered fuel is limited by amount of air which sucked into the cylinder. You can only increase the output power from compressing more air if the energy has been in the best statue. And even improve combustion performance ability. Turbocharger is an only mechanical device that increase the output power under the same work efficiency.