Take Good Maintain To Thrust Bearings

Generally speaking, thrust bearing is used on the parts which under axial load side and in high speed, such as crane hook, vertical pump, Hoisting jack and speed reducer. Bearing ring, seat and roller are separate and could assembly and disassembly respectively.

Pump which used just now usually should change the grease after working 100 hours. Then you can change it about 500 hours once. Thrust ball bearing which use grease had better change the grease 1500 hours once, filling oil quantity should be moderate. The thrust ball bearing will be heating because without appropriate amount of grease. In general, the gas volume had better in half or even more.

Container for lubricating oil and lubricating grease should be clean and also in good daily sealing. Dust, debris and other sundries can not exist. So that it will not damage trust ball bearing. Motor thrust ball bearings often use sodium base grease. This nature of the lubricating grease can be resistant to high temperature. But it can dissolve in water. So don’t this lubricating grease in trust ball bearing.